Malaysia Watch Forum
Main Forums => General Discussion - Modern Watches => Topic started by: shanky0 on December 19, 2023, 07:30:09 AM
-
I was thinking of resizing my tudor watch and was looking up list of Tudor shop, just noticed there is no Tudor boutique. Can I just walk into any boutique and have them resize it for me or do I need to go back to the AD I bought the watch from? Was thinking to get it done in Mid Valley where I have some errands to run and I don't mind paying for the resizing. a bit lazy to go back to the original AD at Lot 10.
Any1 has experience who u they can share? Thanks.
Sent from my 21081111RG using Tapatalk
-
The tudor shop at g floor in Midvalley is a boutique right? The one opposite bell and Ross.
Sent from my SM-S916B using Tapatalk
-
One Utama has Tudor boutique and any dealer that sells Tudor will do resizing with no charges I believe
-
One Utama has Tudor boutique and any dealer that sells Tudor will do resizing with no charges I believe
depends.. had a local ROLEX AD remove a link and he asked for RM20 service charge..
-
If you have the proper tools you can DIY...not too difficult actually.
I regretted sending one of my watches before for resizing and it was scratched at the clasp by the AD...
Unless you buy it new from the AD - they resize it when it is still fully stickered reducing the risk of scratches. If you bring it in after you've bought it when the stickers are out - the risk is higher.
That being said, if you are unfamiliar, then going to the AD is your best bet, or any careful watch maker/dealer.