This is the most likely design for the watch:
The basic specifications:
Case: stainless steel 44 mm diameter, 15 mm thick, 24 mm lug width with screw pins. The case will have a brushed finish.
Case back: stainless steel screw down solid with MWF markings (engraved) LE with 1 of XXX engraved.
Crown: stainless steel, screw down. The crown is big, 8 mm diameter 5 mm thick
Crystal: sapphire, slightly domed with AR coating on the inside.
Dial: california style with SuperLuminova, matte black. All hour markers will be SuperLuminova and have the railroad track minute marker, 32 mm diameter
Hands: PAM style with SuperLuminova, the centrally mounted sweep seconds hand will be all black as well with SuperLuminova ball, all hands matte black. The minute hands will reach the minute markers.
Movement: ETA 2824-2 with hacking
Bezel: stainless steel with SuperLuminova at the 12 o'clock position. The bezel will have shallow serrations along the side and the bezel will taper slightly towards the crystal (it will not be flat). 60 click uni-direction bezel.
Water resistant: 300M (30 ATM)
Strap: 24 mm leather, tropic rubber and hopefully NATO as well. Pin buckle with have a brushed finish.
Did I miss anything?