Malaysia Watch Forum
Main Forums => General Discussion - Modern Watches => Topic started by: lowengen on February 14, 2018, 01:21:28 PM
-
Hi all, i have a Zenith Full Open with the 18k gold bazel, and recently i noticed it has some red spots on the bazel (18k gold), which i believe is corrosion. I never had any gold watches before, so am not sure what should i do? will it spread?
-
I had similar experience on my half gold sub..but i used a soft cloth to rub it and it went away...
Sent from my iPhone using Tapatalk
-
I had similar experience on my half gold sub..but i used a soft cloth to rub it and it went away...
Sent from my iPhone using Tapatalk
I tried wiping it wif all d cloth i had, still wont come off.. lol.. as long as it wont spread i'm ok.. its hard to see anyway, only with really good observation at close range u can see it..
-
send to service centre and if under waranty
-
It's just oxidation of the gold. Some yellow gold will start to look warmer, almost rose gold after enough exposure. Same with white gold turning to a "warm steel" look.
Just use a pencil eraser to rub it and it'll return to its original tone.